Book Now
Show Me Tell Me engine bay guide

Suzuki Swift 1.2 Mild Hybrid Motion Engine Diagram

A clear learner-driver guide to the Suzuki Swift Motion Mild Hybrid engine bay, including brake fluid, coolant, engine oil, screen wash and hybrid safety awareness.

Suzuki Swift Motion 1.2 Dualjet Mild Hybrid Driving test preparation
Labelled Suzuki Swift 1.2 Mild Hybrid Motion engine bay showing the brake fluid, coolant, engine oil and screen wash locations
Under-bonnet guide

Suzuki Swift 1.2 Mild Hybrid labelled for Show Me Tell Me

This labelled Suzuki Swift 1.2 Mild Hybrid Motion engine diagram helps learner drivers identify the main under-bonnet components they may be asked about during the practical driving test.

Use the main diagram and component cards below to learn where to find the brake fluid reservoir, engine coolant, oil dipstick and filler cap, screen wash reservoir and 12V battery.

Main engine bay diagram

Know where the key checks are

The labelled image shows the main components you should be able to identify safely before test day.

Suzuki Swift 1.2 Mild Hybrid engine bay guide showing brake fluid, coolant, engine oil and screen wash
Suzuki Swift 1.2 Mild Hybrid Motion engine bay showing the key under-bonnet maintenance points.
Component checks

What each part does and how to check it

Suzuki Swift 1.2 Mild Hybrid brake fluid reservoir
01

Brake fluid reservoir

Location: Towards the rear of the engine bay near the bulkhead.

How to check: Look through the side of the translucent reservoir and make sure the fluid is between the MIN and MAX markings.

Safety note: If the level is low, have the braking system checked rather than simply continuing to top it up.

Test answer: “I would check that the brake fluid level is between the minimum and maximum marks. If it is low, I would get it checked before driving.”
Suzuki Swift 1.2 Mild Hybrid oil dipstick and oil filler cap
02

Engine oil dipstick and filler cap

Location: The dipstick has a bright yellow handle beside the engine. The black oil filler cap is nearby.

How to check: With the car on level ground and the engine cool, remove the dipstick, wipe it clean, reinsert it fully and remove it again. The oil should sit between the MIN and MAX marks.

Top-up: Use the grade stated in the vehicle handbook, add a little at a time and avoid overfilling.

Test answer: “I would use the dipstick to check that the oil level is between the minimum and maximum marks.”
Suzuki Swift screen wash reservoir with blue filler cap
03

Screen wash reservoir

Location: At the front corner of the engine bay, identified by its blue cap and windscreen-washer symbol.

How to check: Open the cap and visually check whether the reservoir needs topping up.

Tip: Use a suitable screen wash mixture rather than plain water, particularly during cold weather.

Suzuki Swift 1.2 Mild Hybrid coolant filling and expansion tank area
04

Engine coolant

Location: At the front of the engine bay near the battery. Use the translucent expansion tank and its level markings for the routine check.

How to check: Only check the coolant when the engine is cold. The level should be between the MIN and MAX marks.

Important: The metal pressure cap shown in the image is not the point to open for a routine learner-driver check.

Safety warning: Never remove a coolant cap while the engine is hot. Pressurised steam and hot coolant can cause serious burns.
Hybrid safety

Leave hybrid components alone

The mild-hybrid system is not part of the normal Show Me Tell Me checks. Do not touch electrical connections, covered hybrid components or any orange high-voltage cabling. Only identify and check the ordinary service items shown in this guide.

Remember: You only need to explain how you would carry out the check. Do not remove caps or touch hot or electrical components during the test.
Driving test tip

Why this matters for your test

The examiner may ask a Tell Me vehicle-safety question before you begin driving. Knowing the layout of your Suzuki Swift engine bay helps you point to the correct component and explain the check calmly and safely.

Practise Show Me Tell Me
Common questions

Suzuki Swift 1.2 Mild Hybrid Engine Bay FAQs

Where is the engine oil dipstick on a Suzuki Swift 1.2 Mild Hybrid?

The oil dipstick is under the bonnet beside the engine and has a bright yellow handle. Remove it, wipe it clean, reinsert it fully and check that the oil sits between the MIN and MAX marks.

What engine oil should I use in a Suzuki Swift 1.2 Mild Hybrid?

Use the oil grade specified in the handbook for the exact vehicle. The existing guide identifies 0W-20 for this engine, but the handbook should always be checked before topping up.

Where is the coolant tank on a Suzuki Swift 1.2 Mild Hybrid?

The coolant expansion tank is towards the front of the engine bay near the battery. Check the level against the markings only when the engine is cold.

Can I open the coolant cap when the engine is hot?

No. Hot coolant and pressurised steam can escape and cause serious burns. Wait until the engine has cooled fully.

Where is the brake fluid reservoir on a Suzuki Swift?

The brake fluid reservoir is towards the rear of the engine bay near the bulkhead. Check that the level is between the MIN and MAX marks.

Where do I put screen wash in a Suzuki Swift?

Use the reservoir with the blue cap at the front corner of the engine bay. It is marked with a windscreen-washer symbol.

Do I need to know these checks for my driving test?

Yes. Engine oil, coolant, brake fluid and screen wash can feature in the DVSA Show Me Tell Me vehicle-safety questions.

Engine diagrams

More engine bay guides

Choose another vehicle to view a labelled engine bay guide for Show Me Tell Me practice.

Ready to get on the road?

Build confidence before test day

Prepare for every part of your practical driving test with patient, professional tuition from Andrew’s Driving School.